Using Waste Engine Heat in Automobile Engines

Using Waste Engine Heat in Automobile Engines Using Waste Engine Heat in Automobile Engines Automakers are improving fuel economy by exploiting a new controls approach that uses the waste heat from vehicle engines. Currently, up to 65% of the heat energy produced in internal combustion engines, whether gasoline or diesel, is wasted. Typically, the powertrain or engine dissipates the heat by convection, where it is carried to the cooling circuit or lost out of the tailpipe in exhaust gases.A joint team from Chrysler and the Center for Automotive Research at The Ohio State University recently developed a practical approach to maximizing drivetrain efficiency and reducing fuel consumption and carbon dioxide emissions. Together, engineers in industry and research, along with students, determined how to capture and effectively distribute the useful heat energy to the transmission and engine oils from a controls standpoint, requiring additional hardware such as a transmission heat exchange r and associated plumbing, and new software. Higher temperature oil is less viscous, so less torque is required for operation and the transmission and engine can operate at higher mechanical efficiencies.Controlling Oil TemperatureAutomakers can improve fuel economy by selecting optimal coolant-circuit architectures, heat exchangers, and flow-control devices. The goal of this work was to thermisch up the drivetrain oils rapidly and run at a slightly higher temperature without additional hydraulic power. Kevin Laboe, who leads the Powertrain Thermal Management Team at Chryslers Advanced Powertrain Group, Detroit, MI, and who led the simulation and testing teams, says the challenge was to distribute the heat in the most effective way.Currently, up to 65% of the heat energy produced in internal combustion engines is wasted.We first needed to understand how much heat was available from the powertrain during various drive cycles and cold start conditions, he says. By simulating thermal c omponents that control the powertrain heat, such as the electronic thermostat, cooling groupies, grill shutters, and water valve, they determined the best way to distribute the available energy.The team ran simulations to maximize drivetrain efficiency and minimize fuel consumption under various driving conditions, and tested their model-based approach by delivering control commands to actuators that modulated powertrain heat on a test vehicle. They monitored engine coolant temperature, engine oil temperature, transmission oil temperature, and vehicle fuel consumption, and ultimately found no additional coolant pump power was necessary for rapid warm-up and control of the drivetrain oils.All actuators needed to work in concert to heat the oil fast and keep the temperature steady. Opening the grill shutters or running the electric air fan consumes power. Controlling actuators in concert is a new way of addressing thermal management. While more complex, it enables the system to arrive at a steady temperature quicker and under all operating conditions, which extends the life of each thermal-control actuator, Laboe says.Significant Fuel SavingsThe group found that using the waste heat with optimal controls consistently delivered higher oil temperatures and significantly reduced warm-up times. This translated to fuel economy improvements of almost 4% compared to conventional thermal management strategies. The largest efficiency gains occur while heating oil from a cold start, and approximately half of the improvement comes from the powertrain and transmission sides.This type of system is used by a number of suppliers, most commonly in Europe, but hasnt yet come to the market in many areas of the world. Laboe says the amount of increase in fuel economy demonstrated is significant. This technology is coming to meet upcoming regulatory obligations, and Chrysler is interested in this approach because it benefits fuel economy using available energy, and, most importantl y, can be incorporated into existing powertrain architectures.Debbie Sniderman is CEO of VI Ventures LLC, a technical consulting company.We first needed to understand how much heat was available from the powertrain during various drive cycles and cold start conditions.Kevin Laboe, Chryslers Advanced Powertrain Group